Top News

If you use an immersion rod to heat water in winter, then take special care of these things, otherwise your life may be in danger.
Samira Vishwas | November 14, 2025 3:24 PM CST

Immersion Rod Tips: Immersion rod is run on electricity and is inserted directly into an open plastic container of water.

Winter Safety Tips: Emerson rod is used to heat water in middle class families in winter, because it is cheaper to use than geyser. If you also use an immersion rod to heat water, then you need to be careful about some things because your small carelessness while using it can prove fatal.

How is it used?

Actually, the immersion rod is run on electricity and it is inserted directly into an open plastic vessel of water. Since it is open, there is always a risk of electric shock. If there is any kind of fault in the wiring or plug, it can cause shock through water. Therefore, while using it, it is very important for us to take special care of some things.

avoid haste

Many people do not close the immersion rod before taking bath and hurriedly take water from the bucket only when the rod is connected. Doing this can be fatal. Your chances of getting electrocuted through water increases. Therefore, avoid haste and carefully close the rod before draining the water.

keep away from small children

While heating water with an immersion rod, make sure that the rod is completely immersed in water. Failure to do so increases the risk of electric shock. Also, if you have small children in your house, then make sure that you heat water at a place which is out of their reach.

replace old rod

If the immersion rod is old or the wire is burnt. So change immediately. Do not cover any exposed wires with tape. There is always danger from this jugaad. Good quality safety-proof immersion rods are available in the market. Use them only.

Avoid using wet hands

While using the rod, keep in mind that your hands are completely dry. Touching electrical appliances with wet hands is extremely dangerous. Therefore, the plug should never be inserted or removed with wet hands. Also, the socket should be at a height on the wall. So that water splashes do not reach there.

If the immersion rod is used properly then it does not cause any problem. Just keep in mind that the combo of electricity and water is always risky. A little caution can not only save you from an accident. But it also keeps your family safe.


READ NEXT
Cancel OK